技术中心

卡特彼勒CAT966G II装载机保养时间查询表

时间: 2022/5/9    


 

卡特彼勒CAT966G II装载机保养时间查询表

Maintenance Interval Schedule

  966GII轮式装载机操作及保养

注意:在使用机具或操作保养之前必须详细阅读所有安全信息,警告,和使用说明。

在间隔保养前,必须先完成之前间隔期内所须进行的保养。

AXJ00302   966GII WHEEL LOADER Operation & Maintenance
Media Number SEBU7458-05 Publication Date 2003/06/01 Update Date 2003/06/09
SMCS Code: 7000

Note: All safety information, warnings, and instructions must be read and understood before you perform any operation or any maintenance procedure.

Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must also be performed.

在需要时进行  


电池 --回收

       电池或电池电缆--检查/更换

       铲斗磨损--检查/更换

       断路器--重置

       发动机空气滤清器(第一级)--清洁/更换

       发动机空气滤清器(第二级)--更换

       发动机空气初滤器--清洁

燃油系统--加油

保险丝--更换

液压油滤清器--检查

散热器--清洁

蓄能器--检查

窗户清洁装置贮水池--充满

窗户雨刮器--检查/更换

10工作小时或每日

       备用报警--测试

       铲斗边刀--检查/更换

       铲斗斗齿--检查/更换

       冷却液液位--检查

       机油油位--检查

       柴滤初级滤清器(油水分离器)--放水

       油箱内水及沉淀物--排放

       液压油油位--检查

       安全带--检查

       传动系统油位--检查

       窗户--清洁

50工作小时或每周

       下铲斗销轴承--润滑

       驾驶室空气滤清器--检查/更换    

       轮胎充气--检查

100工作小时或每2

       车桥摆动轴承--润滑

       铲斗联接和装载油缸轴承--润滑

       上铲斗销轴承--润滑

       圆木装卸叉夹具--润滑

       转向油缸轴承--润滑

250工作小时或每月

       电池--清洁

       皮带--检查/调整/更换

       制动蓄能器--检查

       制动系统--测试

       差速器及终传动系统齿轮油油位--检查

       驱动轴花键(中部)--测试

       发动机曲轴箱通气孔--清洁

       发动机机油(高速)和机油滤清器--更换

       机油油位取样--取样

       机油和机油滤清器--更换

最初500小时(适用于新系统,替换后系统,和维修后系统)

       冷却液系统冷却液样品(第2级)--取样

500工作小时

冷却液系统冷却液样品(第2级)--取样

500工作小时或每3个月

       差速器及终传动系统齿轮油油位--检查

       发动机机油(高速)和机油滤清器--更换

       发动机机油和机油滤清器--更换

       燃油系统滤清器(油水分离器)--更换

       油箱盖和滤网--清洁

       液压油系统可降解滤清器--更换

       液压油油样--取样

       传动油滤清器--更换

       传动油油样--取样

1000工作小时或每6个月

       铰接轴承--润滑

       电池接头--紧固

       驱动轴支撑轴承--润滑

       驱动轴接头--润滑

       燃油二级滤清器--更换

       盖板翻转调节器--润滑

       防护板铰链--润滑

       防倾覆保护结构(ROPS--检查

       转向控制油滤网(控制转向)--清洁/更换

       传动油--更换

2000工作小时或一年

       制动片--检查

       差速器传动和终传动油--更换

       电器元件触点--检查/调整

       发动机气门间隙--检查

       发动机气门转阀器--检查

       液压油--更换

       液压油箱呼吸安全阀--清洁

       制动摩擦片磨损指示器--检查

       转向轴(转向控制)--润滑

每年

       冷却系统冷却液(第二级)--取样

       制冷干燥剂--更换

安装后每3年或生产后每5

       安全带--更换

4000工作小时或每2

       液压油--更换

6000小时或每3

       冷却液添加剂(ELC--添加

       冷却系统水温调节器--更换

1200工作小时或每6

       冷却液(ELC--更换

When Required

Battery - Recycle

Battery or Battery Cable - Inspect/Replace

Bucket Wear Plates - Inspect/Replace

Circuit Breakers - Reset

Engine Air Filter Primary Element - Clean/Replace

Engine Air Filter Secondary Element - Replace

Engine Air Precleaner - Clean

Fuel System - Prime

Fuses - Replace

Oil Filter - Inspect

Radiator Core - Clean

Ride Control Accumulator - Check

Window Washer Reservoir - Fill

Window Wiper - Inspect/Replace

Every 10 Service Hours or Daily

Backup Alarm - Test

Bucket Cutting Edges - Inspect/Replace

Bucket Tips - Inspect/Replace

Cooling System Coolant Level - Check

Engine Oil Level - Check

Fuel System Primary Filter (Water Separator) - Drain

Fuel Tank Water and Sediment - Drain

Hydraulic System Oil Level - Check

Seat Belt - Inspect

Transmission Oil Level - Check

Windows - Clean

Every 50 Service Hours or Weekly

Bucket Lower Pivot Bearings - Lubricate

Cab Air Filter - Clean/Replace

Tire Inflation - Check

Every 100 Service Hours or 2 Weeks

Axle Oscillation Bearings - Lubricate

Bucket Linkage and Loader Cylinder Bearings - Lubricate

Bucket Upper Pivot Bearings - Lubricate

Logging Fork Clamp - Lubricate

Steering Cylinder Bearings - Lubricate

Every 250 Service Hours or Monthly

Battery - Clean

Belts - Inspect/Adjust/Replace

Brake Accumulator - Check

Braking System - Test

Differential and Final Drive Oil Level - Check

Drive Shaft Spline (Center) - Lubricate

Engine Crankcase Breather - Clean

Engine Oil (High Speed) and Oil Filter - Change

Engine Oil Sample - Obtain

Engine Oil and Filter - Change

Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)

Cooling System Coolant Sample (Level 2) - Obtain

Every 500 Service Hours

Cooling System Coolant Sample (Level 1) - Obtain

Every 500 Service Hours or 3 Months

Differential and Final Drive Oil Sample - Obtain

Engine Oil (High Speed) and Oil Filter - Change

Engine Oil and Filter - Change

Fuel System Primary Filter (Water Separator) Element - Replace

Fuel Tank Cap and Strainer - Clean

Hydraulic System Biodegradable Oil Filter Element - Replace

Hydraulic System Oil Filter - Replace

Hydraulic System Oil Sample - Obtain

Transmission Oil Filter - Replace

Transmission Oil Sample - Obtain

Every 1000 Service Hours or 6 Months

Articulation Bearings - Lubricate

Battery Hold-Down - Tighten

Drive Shaft Support Bearing - Lubricate

Drive Shaft Universal Joints - Lubricate

Fuel System Secondary Filter - Replace

Hood Tilt Actuator - Lubricate

Roading Fender Hinges - Lubricate

Rollover Protective Structure (ROPS) - Inspect

Steering Pilot Oil Screen (Command Control Steering) - Clean/Replace

Transmission Oil - Change

Every 2000 Service Hours or 1 Year

Brake Discs - Check

Differential and Final Drive Oil - Change

Electronic Unit Injector - Inspect/Adjust

Engine Valve Lash - Check

Engine Valve Rotators - Inspect

Hydraulic System Oil - Change

Hydraulic Tank Breaker Relief Valve - Clean

Service Brake Disc Wear Indicator - Check

Steering Shaft (Command Control Steering) - Lubricate

Every Year

Cooling System Coolant Sample (Level 2) - Obtain

Refrigerant Dryer - Replace

Every 3 Years After Date of Installation or Every 5 Years After Date of Manufacture

Seat Belt - Replace

Every 4000 Service Hours or 2 Years

Hydraulic System Oil - Change

Every 6000 Service Hours or 3 Years

Cooling System Coolant Extender (ELC) - Add

Cooling System Water Temperature Regulator - Replace

Every 12 000 Service Hours or 6 Years

Cooling System Coolant (ELC) - Change